Kingston FURY KF318C10BB/4 is a 512M x 64-bit (4GB)
DDR3-1866 CL10 SDRAM (Synchronous DRAM) 1Rx8, memory
module, based on eight 512M x 8-bit FBGA components per module.
Each module has been tested to run at DDR3-1866 at a low latency
timing of 10-11-10 at 1.5V. Additional timing parameters are shown
in the Plug-N-Play (PnP) Timing Parameters section below. Each
240-pin DIMM uses gold contact fingers. The JEDEC
standard electrical and mechanical specifications are as
follows:
• JEDEC standard 1.5V Power Supply
• VDDQ = 1.5V
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• Height 1.338” (34mm) w/heatsink
Kingston FURY KF318C10BB/4 is a 512M x 64-bit (4GB)
DDR3-1866 CL10 SDRAM (Synchronous DRAM) 1Rx8, memory
module, based on eight 512M x 8-bit FBGA components per module.
Each module has been tested to run at DDR3-1866 at a low latency
timing of 10-11-10 at 1.5V. Additional timing parameters are shown
in the Plug-N-Play (PnP) Timing Parameters section below. Each
240-pin DIMM uses gold contact fingers. The JEDEC
standard electrical and mechanical specifications are as
follows:
• JEDEC standard 1.5V Power Supply
• VDDQ = 1.5V
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• Height 1.338” (34mm) w/heatsink
